Installation and precautions of Hydraulic wrench air pump

source:Industry News release time:2021-12-23 Article author:Rosit Popular:Air band saw

　　 Installation and precautions of Hydraulic wrench air pump(pic1)

　　High-pressure blowers can be widely used in industry and agriculture, covering infrastructure, environmental protection industry, automobile industry, electroplating industry, aquaculture industry, industrial dust collection, packaging machinery industry, printing machinery industry, plastic industry, chemical equipment, food packaging equipment, pharmaceuticals In industries, medical equipment, electrical and electronic industries, light industrial textile equipment, ship and railway, aerospace and other industries, it has the characteristics of high reliability, easy portability, easy installation, and easy maintenance.

　　In order to ensure the stability of the operation of the vortex pump, the user must make adequate preparations before operating the equipment:

　　1. Before installing the high-pressure blower, you should be familiar with the various operating requirements of the manual, and check whether the accessories are complete and whether the various technical documents are complete.

　　2. Perform a preliminary inspection of the high-pressure blower to see if the fan is damaged during the logistics and transportation or if there is any damage to the spare parts after long-term storage, and then check whether there is any debris falling into the fan flow channel, whether there is corrosion, etc., and then use tools Rotate the main shaft of the fan or the tail blades of the fan motor to see if the rotation is flexible and there is no friction.

　　3. The configuration of pipes and interfaces (the ratio of pipe diameter to fan outlet diameter is preferably 1.1:1). The fan outlet diameter should be shortened as much as possible, and elbows should be used less, because the more elbows, the greater the pressure loss. .

　　4. Right-angle T-joints should be reduced or not used. The joints of the pipeline should be sealed, and the joints should be wrapped with sealing tape to prevent air leakage to reduce pressure and flow loss. The weight of the pipeline shall not be supported by the fan, and the forced hard connection between the fan and the pipeline is not allowed to prevent the increase of vibration and noise. A soft connection transition should be used.

　　5. According to the foundation bolts, the horizontal plane should be corrected when the fan is installed to prevent excessive tilt and affect the normal use of the fan.

　　6. In order to protect the fan motor, it is best to install a current overload protection device.

　　7. Close the air inlet of the fan, try to start the fan, check whether the rotation of the main shaft of the fan is correct, and then restart the fan. After it runs normally, gradually open the regulating damper and adjust to the required working condition point, but the motor current must not exceed the rated value shown on the label If the required operating point is just the surge point of the wind turbine, the operating point should be adjusted appropriately to avoid the surge point, or other anti-surge measures should be taken.